مصنع لتجهيز البوكسيت/effect of mixing coal powder to water oil
In view of the disadvantage that coal waste powder(CWP) can reduce the crack resistance of asphalt mortar at low temperature, silane coupling agent KH550 was used to modify coal waste powder. The surface characteristics and modification mechanism of silane coupling agent modified coal waste powder were characterized by using Scanning Electronic Microscopy (SEM). Five kinds of silane coupling ...
Summary. Bentonite is a type of clay that is prized for its porosity, workability and nontoxic nature. In foundry applications, it is used with coal (bentonitecoal) in sand/green sand molding for metal castings; where it enhances the refractory properties of the mold whilst also increasing strength and flowability.
Simple manual mixing of hydrophobic coal and water is obviously insufficient to produce a stable suspension. ... 75 g of coal powder and 75 mL of water were at the same time placed in the beaker of a hydrodynamic rotarytype mixer Waring blender 80100 with a twoblade impeller of wedge profile, and the wedge angle of the cavitator was α = 60 ...
The coal is transferred from the mixing bins to the coal crusher where it is pulverized to a preselected size between and mm ( and in.). ... The pulverized coal is then mixed and blended, and sometimes water and oil are added to control the bulk density of the mixture. The prepared coal mixture is transported to the coal ...
DOI: / Corpus ID: ; Synergistic effects of mixing waste activated carbon and coal in coslurrying and CO2 cogasification article{Wang2021SynergisticEO, title={Synergistic effects of mixing waste activated carbon and coal in coslurrying and CO2 cogasification}, author={Jianbin Wang and Jian Chen and Jianzhong Liu and He Liu and Mingxia Wang and Jun Cheng ...
Municipal sludge (MS) is used to prepare coal water slurry (CWS). This practice is beneficial for resource utilization and reduces treatment costs and environmental pollution. In this study, alkalimodified municipal sludge (AMS) was prepared with Ca(OH)2 as modifier and mixed with coal to produce AMSCWS. The effect and mechanism of MS and AMS on slurry ability, stability, and combustion ...
Coal powder was placed in a xanthan gum solution having concentration identical to that of the WCWS. The adsorbed suspension was subjected to highspeed centrifugation to separate the wet coal powder. The coal powder was dried in an oven at 60 °C, and pressurized and polished into a tablet with a thickness of mm and diameter of 2 cm.
The pulping steps were as follows [22]: (1) measure out the weights of coal powder, additives, and liquids (deionized water and waste oil) required to make up the slurry; (2) pour the additives and liquids into a stirring tank with a capacity of 200 mL and adjust the speed of the mixer to 400500 r/min to fully dissolve the additives; (3) add ...
Results show that the addition of sludge can improve the static stability for slurries prepared by lean coal, coking coal, and lignite. The effect on stability of coking coalwater slurry is the most significant. The proportion of sludge to lean coal added in the slurry can be maintained at 10% to 15%.
Some collectors are made by mixing the common oily collectors with the surfactants to enhance the flotation of low rank/oxidized coals because the surfactants can improve the dispersion properties of common oil droplets in flotation pulp and the adsorption of oil droplets on the coal particle surface (Çelik, 2004, Chander et al., 1994, Polat ...
Coal water slurry (CWS) is a fuel which consists of fine coal particle suspended in water. Presence of water in CWS reduces harmful emissions and makes the coal explosion proof thus makes it useful as a liquid fuel. The concept of coal water slurry dates back to Smith and Munsell (1879) [1] when patented for coal oil
The main purpose in this study was to understand the interactions of coal particles with three amphiphilic humic acidbased polymers, which were designed and synthesized through the copolymerization of humic acid (HA) with maleic anhydridepolyethylene glycol 400 monoester, methacrylatoethyl trimethyl ammonium chloride or both of them, respectively, abbreviated as HAM, HAD and HMD.
The mixed collector can improve low rank coal flotation efficiency, but its synergistic mechanism needs to be further explored. In this paper, oleic aciddodecane (OAD), oleic acid (OA), and dodecane (D) were employed to treat the low rank coal for revealing new synergistic mechanism of the mixed collector. First the surface free energy of the coal, the surface free energy of coalwater and ...
Fly ash is a fine powder recovered from gases created by the burning of coal. It is the largest component of coal combustion waste, totaling around 70 million tons annually in the United States ...
2) A specific mass of water is poured into a mixing tank, and the speed of the electric mixer (JHS2) is adjusted to 200 r/min, after which additives are added and fully dissolved in the water. 3) The weighed coal powder is added to the mixing tank, and the speed of the mixer is raised to 1000 r/min and kept there for 15 min. 4) The slurry is ...
Of the different additives, the viscosity reduction effect of Tween 80 in the waste oilcoalwater slurry was best. Further, the comprehensive performance of the waste oilcoalwater slurry, including slurry ability, stability and fluidity, was found to be best at a water content of 10% and a Tween 80 content of 5%.
The particle sizes of the two types of MDS are smaller than those of the dust and sludge from the common iron and steel metallurgical process. 45 This indicates that SFD and WOS are more conducive to mixing with coal and there are more contact points after mixing with pulverized coal, which is beneficial for improving the catalytic effect.
The present review paper summarizes the uptodate research advancements made in the use of mixed reagent systems to improve the separation efficiency of coal flotation. Experimental and molecular dynamics simulation approaches have been adopted to enhance floatability, and reagent adsorptions are also discussed.
The coal pitch water slurry was prepared by coal pitch powder, dispersants and two different kinds of coking wastewater. The apparent viscosity, rheological behavior and stability of the coal pitch water slurry were investigated. The results indicated that both the two kinds of coking wastewater could be used to prepare coal pitch water slurry. Moreover, the adsorption of dispersants and zeta ...
void fraction of the coal powder beds is the porosity of particle bed when the voids of coal particle bed are filled with water. Void fraction of CWS was calculated by the following equation (Henterson,, 1978). ε = V. s V. c (2) V. s. where ε, V. c, V. s . referred to as void fraction, volume of coal, and volume of slurry ...
In this study, a microemulsion was prepared by mixing dodecyl trimethylammonium bromide (DTAB) and diesel oil; its effect on lowrank coal flotation was studied via water contact angle and wrap angle measurements. The results show that the clean coal could not be effectively recovered using a single reagent of DTAB or diesel oil.
Herein, a method of mixed combustion of meager coal and SCCB in a pulverized coal furnace for disposal of SCCB is proposed, and thermogravimetric mass spectrometry (TGMS) is used to characterize the combustion and gas release characteristics. The effects of the heating rate and mixing ratio on combustion are analyzed as well.
The effect of addition sequence for mixed collectors comprising of dodecane(D) and nvaleric acid(A) on lowrank coal flotation was explored by the following three sequences: D first and then A(D + A), A first and then D(A + D), D and A were added simultaneously(M). The total organic carbon, contact angle, zeta potential, and Xray photoelectron spectroscopy results revealed that the coal had ...
Performance of fiber reinforced asphalt concrete under environmental temperature and water effects. Constr. Build. Mater. (2010) T. Xu et al. ... Effect of coal waste powder in hot mix asphalt compared to conventional fillers: mix mechanical properties and environmental impacts. Journal of Cleaner Production, Volume 91, 2015, pp. 262268 ...
Abstract. Coaloilwater slurry (COWS) synfuel can be prepared successfully by waste engine oil (WEO), water and coal in the existence of Tween 80 and SL. The effects of coal type, coal particle size distribution, and WEO blending proportion (α) on the slurryability of COWS were investigated, and certain essential properties, such as ...
The preparation of stable waterinoil (W/O) emulsion is critical for the success of production of stable coaloilwater slurry. The present study was undertaken to experimentally investigate the effects of different process variables on emulsion stability. The emulsion was prepared using 100 ml colloid mill with sorbitan monooleate (SM) as ...